Publicité
Les langues disponibles
Les langues disponibles
15.3 Operation
Attention
► Do not dissolve feeding tube with cover during use.
► Do not put hand or any object into the device or feeding port, otherwise harmful
accident may occur or the device may be damaged.
1. Connect the power, after you properly installed the device.
2. Prepare the ingredients.
Warning
► Do not touch the power cord with wet hands. It may cause electrical shock, short-circuit
or fire.
3. Press the ON(I) button to operate.
4. Insert the prepared ingredients one piece at a time into the feeding tube.
Please note
► After inserting ingredients, use the pusher when it is necessary. Too much use of the
pusher may affect the juice quality. Intermittently use the pusher for soft ingredients like
tomatoes and apples. Constant use of pusher for soft ingredients may affect the juice
quality.
5. When you want to make mixed juice then close the closure of juice flow. So the juice
remains in the juicing barrel and the juices intermixes. You can make choose from
different fruits and vegetables to create your own mixed juice.
6. Close the closure of juice flow after making juice to to prevent dripping, especially if you
disassemble the juice barrel from the motor block.
Please note
► You can make different juices fast after each other when you let one glass of water (with
closed closure of juice flow) run through the device. So you can flush away residues
and aromas.
► Leave closure open when juicing ingredients that create excessive foam during
extraction (e.g. apples, celery).
► Pay close attention when operating with the juice flow closed. Juice may overflow if the
juice collected in the juicing bowl exceeds its capacity markes on the bowl.
7. After juice and pulp are completely extracted, switch the unit off (O).
Please note
► If the remaining ingredients in the juicing bowl have not been extracted completely, the
drum lid may not open easily. After each extraction, run the juicer for an additional 30
seconds to let the juicer extract the remaining pulp.
► When the drum lid is stuck, press the REV(II)-O-ON(I) button in this order, switching
back and forth for 2 or 3 times to dislodge the ingredients.
► Depending on the ingredients, pour water down the feeding tube to rinse out the interior
of the juicing bowl and then attempt to remove the drum lid.
► After juicing ingredients with seeds like grapes, thoroughly clean all the crevices on the
bottom of the pressure auger.
Caso Entsafter „Whole Slow Juicer" SJW 400
42
Publicité
