Caso Germany 3502 Mode D'emploi Original page 40

4. Feeding tube, cover and pusher
Place the feeding tube with cover (1), so that the red points are place directly above each
other (2). Take care that the feeding tube is place centered on the pressure auger. Turn
the cover to the left in direction of the arrow until it is locked in place. Place the pusher into
the feeding tube (3).
5. Juice bowl and residual bowl
Place the juice bowl under the juice flow and the residual bowl under the residual opening.
Please note
► The juicer may leak if not assembled properly.
► Juicer will not operate if parts are not assembled properly.
► The pressure auger must be latched, in order to close the feeding tube with cover.
15 Operation and Handling
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.
15.1 Before first use
Clean the device, see "cleaning".
15.2 Preparing the food for making juice/smoothie
Hard seeds:
Peaches, nectarines, apricots, plums, mangoes, etc. Remove hard seeds from the
ingredients before juicing.
Hard or inedible skins:
Pineapples, melons, mangoes, oranges, etc. Peel the skin from the ingredients before
juicing.
Caso Entsafter „Whole Slow Juicer" SJW 400 40