Publicité
Les langues disponibles
Les langues disponibles
OPENING THE BOX AND ASSEMBLING
List of box contents :
•
A vertical digital signage Terminal pole.
•
A power supply cord, standard European "F" type plug.
•
A safety key to open the rear hatch of the terminal.
•
A remote control.
•
A set of screws and washers with an allen key.
Opening the box and assembling the Terminal (2 people) :
1.
Place the box on its edge on a flat surface with the carrying handles facing up.
2.
Open the top cover.
3.
Remove the cushioning blocks from both sides of the box.
5.
Remove the unit from the carton (Fig. 5) and place it on a flat table previously covered with a soft cloth or
bubble wrap to prevent scratching. Check that there is no dust or foreign matter on the table before laying the
terminal flat.
6.
Carry out a visual inspection of all components.
Important :
Contact your dealer in the following cases :
a.
If the carton was delivered to you damaged (take a picture and do not proceed with unpacking or
installation without your dealer's permission).
b.
If there are missing or damaged items in your carton.
c.
If the appliance does not switch on after being plugged in and using the switch (check with another
electrical appliance that the wall socket is supplied with power).
d.
If the operation seems abnormal: unstable picture, crackling, burning smell (in this case, immediately turn
off the power and unplug from the wall socket
Page 16 de 20
Publicité
