Your Véro Stove At A Single Glance; Installation; Lighting The Stove - WANDERS Vero Mode D'emploi Et Instructions D'installation

Your Véro stove at a single glance
The Véro 33 Serpentino
The Véro is a combination of comfort and efficient heat
emission. The large glass panes allow emission of the
heat from the stove directly to the environment to make
your room instantly comfortable. The built-in flue gas
deflector ensures circulation of flue gases in the interior
parts. Combined with the extra after-burning, it means
that the flue gases have better combustion and reduce
the burden on the environment. You can regulate the
intake of combustion air with the integrated air slide
valve and adjust the intensity of the fire and the output
of your stove.

Installation

It is common practice for the dealer where you purchased
your Véro stove to also take care of installing it. If this is
not the case, please ensure that the installation is done by
a certified installer. A certified installer can also give you
the right advice about the flue tube to which the stove
must be connected. Connecting wood-burning stoves
by unqualified persons is prohibited, in which case we
cannot give any guarantee about proper functioning of
your Véro stove. Please bear the fire safety in mind when
installing the stove. See also page 22.
The wood-burning stove is suitable as an extra heat
source and does not replace your principal heating
device.
Usage early in autumn or late in winter
When the external and internal temperatures do
not differ much, a proper chimney draught is a real
challenge. You can help chimney draught get started
by burning some wood while keeping all air inlets
maximally open. An abundant air supply speeds up
quick heating which in turn increases the draught
in the chimney. Lighting up the stove with only a
little wood prevents smoke from streaming into the
room.

Lighting the stove

The stove will become very hot when you light it and
will need at least two hours to cool off. Don't touch the
stove without protection during firing and for two hours
after. Handle the stove always with a glove to avoid
getting serious burns.
Before lighting the fire, you must clean away any deposits
on the window pane with a paper from a kitchen roll.
The same paper can be used for lighting the fire.
Open the combustion air inlet. Open the slide to its
maximum before lighting the stove. Then open the door
and put some balls of paper or firelighters in the stove
and place some wood kindling on top. Light the kindling
and leave the stove door ajar (for 3 to 5 minutes) for
extra air supply and enhancing chimney draught. Once
the kindling has caught fire you can add extra wood.
(Put the logs loosely on the fire so that the flames can
catch on all around).
How the air valve works
The air valve has 3 positions:
1. Opened all the way: the primary and secondary air
supply is open.
2. Pressed until the first click is heard: only the sec-
ondary air supply is open and the stove will pro-
duce the highest yield while the glass cleaning sys-
tem works optimally.
3. Pressed until the second click is heard: everything is
closed, and the fire will go out slowly.
17