Fein 7 221 86 Mode D'emploi page 29

OBJ_BUCH-0000000178-001.book Page 29 Tuesday, December 16, 2014 1:23 PM
Securing the workpiece (figure 15).
Secure the workpiece sufficiently. An
inadequately secured workpiece can, for
example, cause the grinding accessory to
jam. This can lead to kickback, cause the
workpiece to fall down, and lead to
other dangerous situations.
Dry grinding (figure 16).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 17).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig. 15
Fig. 16
Fig. 17
en
29