Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000178-001.book Page 26 Tuesday, December 16, 2014 1:23 PM
en
26
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off.
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start lock prevents the angle grinder
(see Table) from automatically restarting
again, even after a brief interruption of the
power supply, e. g., from a pulled power plug.
WSG8-115/WSG8-125/WSG11-125/WSG11-150/WSG12-125P/WSG15-125P/WSG15-125PS/
WSG15-150P/WSG15-70 Inox (figure 10).
Switching on:
Push the On/Off switch forward (I).
Switching off:
Push the On/Off switch back ().
Angle grinders with electronics (see Table)
are equipped with overload and blocking pro-
tection. In case of overload or blocking of the
application tool, the power supply is inter-
rupted. in this case, switch the power tool off,
remove it from the workpiece and check the
application tool. Afterwards, switch the
power tool on again.
WSG12-125P
WSG15-125PRT
WSG15-125P
WSG15-150PR
WSG15-125PS
WSG15-150PRT
WSG15-150P
WSG15-70 InoxR
WSG15-70 Inox
WSG15-70 InoxRT
WSG15-125PR
Fig. 10
On/Off switch
Publicité
