Danby DBC044C1SSDB-6 Manuel Du Propriétaire page 6

OPERATING INSTRUCTIONS
DOOR CONDENSATION
In times of high ambient temperature of humidity
condensation may appear on the inside of the door.
This is normal and is due to warm air being trapped
inside the cabinet.
Wipe the glass with a soft, dry cloth to remove
condensation and consider setting the set
temperature slightly higher.
Always ensure that the door is fully closed when
the appliance is in operation. Failure to fully
close the door can lead to excessive condensation
and potential water damage to fl ooring under
the appliance. Danby will not be responsible for
damages from misuse.
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the hinge cover and the upper hinge
from the upper right side of the cabinet. Remove
the hole covers from the upper left side of the
cabinet. Remove the door from the cabinet.
2. Remove the door stop from the lower right side
of the door and install it on the lower left side of
the door.
3. Remove the adjustable foot from the lower left
side of the cabinet. Remove the lower hinge
and the adjustable foot from the lower right
side of the cabinet. Install the adjustable foot on
the lower right side of cabinet. Install the lower
hinge and the adjustable foot on the lower left
side of the cabinet.
4. Install the door on the cabinet. Install the hole
covers on the upper right side of the cabinet.
Install the upper hinge on the upper left side of
the cabinet. Before tightening the screws in the
upper hinge ensure that the top of the door is
aligned with the top of the cabinet and that the
rubber gasket is making a good seal with the
cabinet all the way around.
1
2
3
4
5