Publicité
TROUBLESHOOTING
appliances being used. If the troub!
SYMPTOM
CAUSE
REMEDY
1. Disc table is not ejected when
is pressed.
@
Power switch is not turned on.
@
Plug in power cord,
@ Turn on power switch.
2. Disc table comes out.
e
Disc is dirty.
@ The disc is not properly set on the disc table.
®
Moisture has condensed on parts in the player.
@
Disc is warped.
®
Clean disc.
®
Try to alleviate the warp.
(Refer to
@
Set the disc properly.
@
Remove disc and let player stand for 1 to
2 hours until it is dry.
Symptom 7, remedy column.)
3. Remote contro! does not work.
@
Batteries are weak.
@ Aim the remote
control unit at the
®
Replace batteries.
@
Remove the obstacle or shift the remote
@
Operate the remote control unit in front
|
projection monitor or AV amplifier.
control position.
of the player.
4. Operation of the remote control
unit causes the TV to operate
improperly.
4
@
Move the TVand the player further apart,
or cover the remote sensor of the TV
during disc playback,
REMEDY
5. Disc is rotating but there is no
picture.
@ The TV set is not turned on.
@
Wrong connections from player to TV.
@ Turon TV.
®@ Make correct connections.
@ Adjust vertical-hold control on TV.
7. Particular disc does not playback
properly. The playback stops in
the middle of the disc program.
The playing surface of the disc is dirty.
The disc is warped.
@
Use a soft cloth and lightly wipe off the
@
LD discs only
dirt from the surface of the disc. If
necessary, moisten a cloth with diluted
neutral detergent to remove heavy dirt or
fingerprints.
Put the disc into the protective envelope,
then
place
it on
a flat desk
top
Subsequently, place a flat board on the
disc, and load it with about 4 ~ 5 kgs. If it
isleftin this state
for one day, sometimes
the warp will be alleviated.
Heavy books
about 4 ~ 5 kgs.
LD disc-
Y
i
"<2
Protective
Flat board
envelope
80
<VRE1021>
En
Publicité
