Publicité
Les langues disponibles
Les langues disponibles
Installation and Aiming
1.
Install the Easy Aimer and transducer assembly by bolting the mounting block
directly to the bin or via a mounting plate.
2.
Leaving the sighting block binding screws fastened and loosen the angle block
binding screws. Rotate the angle block until the transducer is pointing at the desired
angle. Refasten angle block binding screws.
3.
Loosen the sighting block binding screws and rotate sighting block until the
transducer is pointing in the desired direction. Sighting reference graduations on
the mounting block are 30° apart. Refasten sighting block binding screws.
angle adjustment
sighting adjustment
mounting plate
and hardware
(customer
supplied)
block binding
screws, 6 places,
tighten to 3 N-m
(25 in lb) of torque
recommended gasket
thickness 1.5-1.8 mm
(0.06"-0.07")
(customer supplied)
mounting plate with
welded studs
(customer supplied)
7ML19985HG61
basic installation
sealed installation
Easy Aimer 2 – INSTRUCTION MANUAL
conduit gland
tighten to 95 N-m
(70 ft lb) of torque
mounting
hardware,
3 places, tighten
to 8 N-m
(6 ft lb) of torque
Page 3
Publicité
