Publicité
Les langues disponibles
Les langues disponibles
us_main.book.book Page 22 Wednesday, January 29, 2020 2:11 PM
22 INSTALLATION
Leveling and Door
Alignment
Leveling
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the refrigerator seems unsteady, or the
doors do not close easily, adjust the refrigerator's
tilt using the instructions below:
1
Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2
Open both doors and check to make sure that
they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.
Door Alignment (Door-in-Door
Model)
Left Refrigerator Door
The left refrigerator door has an adjustable nut,
located on the bottom hinge, to raise and lower
the door for proper alignment.
If the space between the doors is uneven, follow
the instructions below to align the left door:
Use the wrench (included with the owner's
manual) to turn the nut in the door hinge to adjust
the height. Turn the nut to the right to raise the
door or to the left to lower it.
Right Refrigerator Door
The right refrigerator door does not have an
adjustable nut.
If the space between the doors is uneven, follow
the instructions below to align the right door:
1
With one hand, lift up both the inner and
outer door sections of the right door to raise
them at the middle hinge. (It may be easier to
lift it with the doors open.)
2
With the other hand, use pliers to insert the
snap ring on the middle hinge of the inner
door section as shown. Do not insert the ring
on the hinge of the outer door section.
3
Insert additional snap rings until the right
door is aligned. (Two snap rings are provided
with the unit.)
Turning on the Power
• After installing, plug the refrigerator's power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
CAUTION
• Connect to a rated power outlet.
Publicité
