Publicité
Les langues disponibles
Les langues disponibles
2. Press the PRG button again, press
to select the time, on
to select Comfort
mode for 24 hours.
NOTE: If the power supply is cut, after recovery, set the time again and the unit will be in
the mode and temperature before the power failure.
Function window opening and closing detection
Press
to enter the window opening and closing function. The appliance will enter
comfort mode by default. The appliance automatically switches to frost protection mode if
temperature dropped detected. As soon as the unit detects an increase in temperature, it
automatically returns to comfort mode. You can press M or PRG to select the other modes,
or press the standby button to enter the standby mode.
NOTE: Under the window opening and closing detection function, the pilot wire mode is not
available.
5. IN CASE OF PROBLEMS
- The appliance does not heat:
Ensure that the circuit breakers are switched on
the installation, or the shedder did not cut the
power supply (if the installation has one).
Select the COMFORT mode.
Increase the temperature setting.
- The appliance heats continuously:
Ensure that the device is not in a draft.
Reduce the temperature setting.
- The pilot wire programming does not work:
Select the COMFORT mode.
- The LED flashes rapidly:
Failure of the temperature sensor (Do not switch
on the radiator as can be dangerous).
GB-12
Publicité
