Makita LS1018 Manuel D'instruction page 9

ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and unplugged before working on the tool.
Failure to switch off and unplug the tool may result
in serious personal injury.
Storage of socket wrench with hex wrench on
its other end
011338
The socket wrench is stored as shown in the figure.
When the socket wrench is needed it can be pulled out
of the wrench holder.
After using the socket wrench it can be stored by
returning it to the wrench holder.
Installing or removing saw blade
WARNING:
Always be sure that the tool is switched off
•
and unplugged before installing or removing
the blade. Accidental start up of the tool may
result in serious personal injury.
Use only the Makita socket wrench provided to
•
install or remove the blade.Failure to use the
wrench may result in overtightening or insufficient
tightening of the hex bolt and serious personal
injury.
1
014686
Lock the handle in the raised position by pushing in the
stopper pin.
1. Socket wrench
2
with hex wrench
on its other end
2. Wrench holder
1
1. Stopper pin
1
010241
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
1
2 3
010242
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
NOTE:
If the inner flange is removed be sure to install it
•
on the spindle with its protrusion facing away from
the blade. If the flange is installed incorrectly the
flange will rub against the machine.
WARNING:
Before mounting the blade onto the spindle,
•
always be sure that the correct ring for the
blade's arbor hole you intend to use is
installed between the inner and the outer
flanges. Use of the incorrect arbor hole ring may
result in the improper mounting of the blade
causing blade movement and severe vibration
resulting in possible loss of control during
operation and in serious personal injury.
1
010244
9
1. Socket wrench
2
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Blade case
4
2. Socket wrench
5
3. Hex bolt
4. Arrow
5. Shaft lock
1. Blade case
2
4
2. Arrow
3
3. Arrow
4. Saw blade