Xylem FLOJET BW5000 Serie Mode D'emploi page 2

Figure 1
A
A. Main module with On/Off rocker switch
B. Suction Wand and Hose Assembly
C. 20 ft (6.1m) of 1/4 in. (6.35mm) Discharge Tube
D. Outlet port fitting kit
E. Wall power transformer
Wall Power
Transformer
Push clip up
to lock
Insert float sensor switch plug/connector into
pump module "SWITCH" port.
The connections for the float and power
supply will require moderate force to insert
fully. This is a design feature that assures the
connections are held securely after initial
installation. MAKE SURE PLUG / CONNECTOR
IS INSERTED ALL THE WAY INTO THE
CONNECTIONS. FAILURE TO INSERT FULLY WILL
LEAD TO POOR OPERATION OR NO OPERATION.
Grounded Outlet
Power Cord
To install tube into "OUT" port.
Push 1/4" discharge tubing all
the way into quick connect port
(as far as it will go).
Insert DC plug/connector into
pump module "DC IN" port.
The connections for the float and power
supply will require moderate force to
insert fully. This is a design feature
that assures the connections are held
securely after initial installation. MAKE
SURE PLUG / CONNECTOR IS INSERTED
ALL THE WAY INTO THE CONNECTIONS.
FAILURE TO INSERT FULLY WILL LEAD TO
POOR OPERATION OR NO OPERATION.
Insert suction hose port fitting into
pump module "IN" port and slide
locking port clip in place.
2
C
D
E
B