Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Carefully lift the mirror cap cover to create a gap.
gap
3
NOTE: Front Flange
clip in place
underneath the
mirror cap
5
Gently press the exposed areas of tape against the surface and
verify position. With the front visor in its final position, remove the
remaining tape liner by pulling on free end.
6
Rear Visor
Peel back 2" (5cm) of tape liner from each end
of top flange. Remove tape liner from
front flange. Remove tape liner from rear flange.
free end
top flange
8
rear flange
(remove tape liner) (remove tape liner)
NOTE: Actual application may vary slightly from illustrations.
Align the Front Visor on the outside of the door frame.
mirror cap
free end
front flange
While lifting mirror cap, slide front flange of visor
underneath it. Release mirror cap.
Front
Flange
4
Apply firm pressure along all flanges to ensure proper adhesion of
7
Align the deflector with the edge of front and rear doors.
align
9
Page 2 of 3
tape.
Publicité
