Publicité
Les langues disponibles
Les langues disponibles
012484
Hold the trimmer with both hands and pull the switch
trigger A or B and then move it in front of your body.
1
2
012485
As a basic operation, tilt the blades towards the trimming
direction and move it calmly and slowly at the speed rate
of 3 - 4 seconds per meter.
1
012486
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
012487
Attaching the chip receiver (optional accessory) on the
tool when trimming the hedge straight can avoid cut off
leaves' being thrown away.
1. Trimming
direction
2. Hedge surface
to be trimmed
3. Tilt the blades
3
1. String
012488
To cut a hedge side evenly, it helps to cut from the bottom
upwards.
012489
Trim boxwood or rhododendron from the base toward the
top for a nice appearance and good job.
Installing or removing chip receiver
(optional accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing chip
receiver.
NOTE:
When replacing the chip receiver, always wear
•
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
Always be sure to remove the blade cover before
•
installing the chip receiver.
The chip receiver receives cut-off leaves and
•
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
2
1
4
012493
Press the chip receiver on the shear blades so that its
slits overlap with the nuts on the shear blades.
7
1. Press
2. Chip receiver
3. Nut
4. Shear blade
3
Publicité
