LEGRAND MP2.10-MP4.10 Manuel D'instructions page 66

Protection unit MP4.10
1.2
Remove the front cover of the breaker.
Insert the 4 batteries in the lower part of the protection unit, respecting the polarity and the assembly
sequence indicated into the picture.
The battery kit is supplied as standard.
During configuration and
prolonged consultation
out of service, we
recommend the use of
the EMS module power
supply (item 4 149 45)
to reduce excessive
batteries consumption.
If necessary, it's available
the kit ref. 0 290 21.
66
Inserting/replacing the batteries
At the end of life cycle, process
the
according to the EU directive
2006/66/CE about the batteries,
accumulators and relative wastes.
CR2 battery
3V lithium
included batteries