Euroflex Monster EZ1 Manuel D'utilisation page 10

All manuals and user guides at all-guides.com
C. Using Steam
• To emit steam from the
Steam Nozzles, push the
trigger on the Handle.
*IMPORTANT*
The Steam Nozzles are meant
to be used in steam "bursts"
and should never be used on
a sustained basis. The Steam
Nozzles will loosen especially
difficult debris and will also
assist in treating hard to
reach areas.
The Floor Steamer will stop producing steam when the Boiler is
empty. When this happens unplug and store unit or refill with
water per instructions (1D).
D. Refilling Boiler During Use
WARNING: Let Steamer cool 10 minutes before opening Boiler
Cap. Use care when opening the Boiler Cap – it may still be hot
and steam may escape, causing burns. If Boiler is still hot, water
may spurt out during refilling – this can also cause burns.
• Unplug appliance.
• Press trigger on the Handle to clear steam from Steam Nozzles.
• Press down and slowly turn Boiler Cap counterclockwise. This will
allow remaining steam to escape.
• Be sure Steamer has cooled 10 minutes before refilling with water.
• Fill Boiler using Measuring Cup provided. Be sure Steamer Handle
remains in the upright "Off" position.
• Firmly push down and screw Boiler Cap back on by turning it
clockwise.
• Insert plug into 3-prong electrical outlet.
REMINDERS
• Always use tap water.
• If tap water is too hard, use distilled or demineralized water to
avoid the risk of staining pale colored fabrics.
• Do not add detergents, perfumes, oils or other chemical
substances.
10
Using Your Floor Steamer
(continued)
NOTE: Your Steamer will not need
the Boiler refilled for up to 30
minutes.