Publicité
Les langues disponibles
Les langues disponibles
Electrical
connection
• ,
WARNING
RISK OF ELECTRIC SHOCK
Parts inside the appliance can have sharp edges.
The connection
cable can be damaged.
Do not
bend or pinch connection
cables during installation.
Before connecting
the appliance,
check the household
installation. Ensure sufficient fuse protection
of the
household
installation. The voltage and frequency of the
appliance
must match the electrical installation
(see
rating plate).
The appliance complies with protection class 1 and must
only be operated in conjunction
with a protective
conductor
terminal.
An all-pole isolating switch with at least a 3 mm contact
gap must be fitted in the installation. This must remain
accessible
after installation.
Only a qualified electrician who takes the appropriate
regulations
into account may lay or replace the
connecting
cable.
Follow all valid standards
and laws.
Ensure that the electrical connection
meets the
requirements
of the latest version of all applicable
standards and laws in the appropriate
country, especially
the following standards: National Electrical Code, ANSI/
NFPA 70*, or CSA Standards C22.1-94,
Canadian
Electrical Code, Part 1 and C22.2 No.0-M91**
Have a qualified electrical technician
check the
grounding
of the appliance.
Do not ground with a gas line.
No fuse protection
in the neutral or grounding
circuit.
Keep the installation instructions.
Only connect the
appliance with a copper conductor.
If possible, connect
the appliance
to a metal cable guide directly to the fuse
box.
Ensure that the wire diameter meets the requirements
of
the latest version of all applicable
standards and laws in
the appropriate
country, especially the following
standards:
National Electrical Code, ANSt/NFPA
70*, or
CSA Standards C22.1-94, Canadian Electrical Code, Part
1 and C22.2 No.0-M91**.
Put a protecting
hose that is listed in the U.L. or C.S.A. on
both ends of the connecting
cable, that is, on the
appliance
and on the fuse box.
For copies of the standards
listed, contact:
* National Fire Protection Association
Batterymarch
Park
Quincy, Massachusetts
02269
** CSA International 8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
Before You Begin
Tools and Parts Needed
o Measuring tape
o Pencil
o Phillips screwdriver (Posidrive)
#2
o Drill with the following bits: 5/16" (7.9 mm) and 3/8"
(9.5 mm)
o Spirit-level
o Aluminum tape (DO NOT use insulating tape)
o Exhaust channel (configuration
depends on the
installation situation)
o Additional
sheet metal screws (if necessary for
installation of the exhaust air duct)
o Saw
Parts Included
o Extractor hood with fan, back-pressure
flap
o Lamp, already installed
o Metal grease filter
o Flue duct
o Drill template
o lx angle bracket for the flue duct
o Installation manual and instructions for use
o 6x screws, 5x45 mm
o 8x screws, 4x8 mm
o 2x washers
o 2x hollow wall plugs, 8x40 mm
o 4x hollow wall plugs, 10x50 mm
o Torx adapter, 10 & 20
Publicité
