Publicité
Les langues disponibles
Les langues disponibles
User manual and warranty card
LINE ADJUSTMENT
The cables may stretch and contract during use. They should then be checked and properly adjusted
(if adjustment is available on your model). To do this loosen the small locking nut 1 (Fig. 19) and then
depending on your needs:
1 turn the adjusting nut 2 (Fig. 19) counterclockwise: the cable is shortened,
2 turn the adjusting nut 2 (Fig. 19) clockwise: the cord will be extended.
LUBRICATION
To lubricate the rear drive wheel rack 8 (Fig. 1) you should:
1. Remove the rear wheel hub cap by turning the hub cap counterclockwise.
2. Unscrew the drive wheel nut with a 13 mm wrench.
3. Remove the drive wheel from the axle.
4. Remove the Seger ring 24 (Fig. (20) and then slide the drive rack off 25 (Fig. 20), from the gear
shaft 27 (Fig. 21).
5. Sprocket, drive carrier 26 (Fig. 21) and the gear shaft must be cleaned of grease residues and
lightly grease the above elements. The recommended grease for this operation is MURRAY bevel
gear grease.
CAUTION! Lubricate the gear wheel from the inside 25 (Fig. 21). Do not lubricate the
outer rim on the sprocket and the drive wheel.
6. Refit the entire mower drive mechanism in reverse order.
TRANSPORTATION
PREPARATION FOR TRANSPORT
• Before transporting the mower, remove oil, then: cool the engine, remove fuel from the tank,
carburettor and fuel lines.
• The device can only be transported in the working position, i.e. at an angle of up to 15 degrees
above the level.
• The handle may be folded.
Attention! Be careful when folding or unfolding the handle, as the cables may be damaged.
Damaged cables can cause the mower to malfunction and in some cases reduce the safety of use
of the device.
25
English
Publicité
