Kohler K-T16113 Guide D'installation page 4

Apply plumbers
putty.
1. Install the Spout
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants when installing slip-fit spouts. If the
spout will not slide over the tubing, use soapy water or a
silicone-based lubricant.
Remove the temporary nipple.
Apply thread sealant and install a 1/2" nipple so it extends 7/16"
(1.1 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant around the inlet
end of the spout according to the manufacturer's instructions.
Apply thread sealant to the nipple and thread the spout onto the
nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty.
1025255-2-C
All manuals and user guides at all-guides.com
Threaded Spouts
Nipple
3-7/8"
(9.8 cm)
4 Kohler Co.