Kohler Sterling 4700 Serie Guide D'installation Et D'entretien page 13

Install the Panel Bracket
Panel Bracket
C L of Door Panel
Longer Towel Bar
Towel Bar
10. Install the Towel Bar
Install the Panel Brackets
NOTE: The towel bar should be installed on the outside panel.
Place a panel bracket on the left hand towel bracket.
Align the hole in the panel bracket with the hole in the towel bar bracket.
Secure with a #8-32 x 5/16" flathead screw.
Repeat the procedure for the other panel bracket and the right hand towel bar bracket.
Install the First Bracket
IMPORTANT! Use one clamp gasket on each side of clear glass panels. Pebble glass panels are thinner;
use two clamp gaskets on each side of pebble glass panels.
Fit a clamp gasket(s) over the left side of the outside glass panel at the horizontal center of the
panel.
Push the left hand towel bar bracket onto the clamp gasket.
Complete the Installation
Insert the longer towel bar into the top hole of the left towel bar bracket, and insert the other towel
bar into the bottom hole of the towel bar bracket.
Fit a gasket on the right side of the door panel, making sure that it is level with the left side towel
bar bracket.
Push the right hand towel bar bracket onto the clamp gasket while pushing the towel bars into the
bracket.
Insert two setscrews into each towel bar bracket and tighten.
Sterling
All manuals and user guides at all-guides.com
#8-32 x 5/16"
Flathead Screw
Panel Bracket
Complete the Installation
Towel Bar
Clamp Gasket
Install the First Bracket
Clamp Gasket
Right Hand Towel
Bar Bracket
13
Clamp Gasket
Open End
Outside Panel
Setscrew
1053310-2-D