Connecting A Cellular Phone; Disconnecting A Cellular Phone - Pioneer DEH-P5100UB Mode D'emploi

Section
06 Available accessories
Notes
! To return to the playback display, press
BAND/ESC.
! Device info. is the same as that of the Blue-
tooth audio. (Refer to Displaying BD (Bluetooth
Device) address on page 39.)
! PH.B.Name view (phone book name view)
cannot be selected for cellular phone regis-
tered guest phone.
! If cellular phone is connected to this unit via
Bluetooth wireless technology with HSP
(Head Set Profile), PH.B.Name view,
Clear memory, Number dial and
Refuse calls cannot be selected.
! If you do not operate functions other than
Search & Connect, Connection open,
Connect phone, PH.B.Transfer,
Disconnect phone, Number dial and
Clear memory within about 30 seconds, the
display automatically returns to the ordinary
display.

Connecting a cellular phone

Searching for available cellular phones
1 Use MULTI-CONTROL to select
Search & Connect in the function menu.
Refer to Function and operation on the previous
page.
2 Press MULTI-CONTROL to search for
available cellular phones.
While searching, Searching flashes. When
available cellular phones featuring Bluetooth
wireless technology are found, device name or
Name not found (if names cannot be ob-
tained) is displayed.
# If this unit fails to find any available cellular
phones, Not found is displayed.
3 Push MULTI-CONTROL up or down to
select a device name you want to connect.
4 Press MULTI-CONTROL to connect the
selected cellular phone.
While connecting, Connecting flashes. To
complete the connection, check the device
42
En
name (Pioneer BT Unit) and enter the link
code on your cellular phone. If the connection
is established, Connected is displayed.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 31.
Using a cellular phone to initiate a
connection
1 Use MULTI-CONTROL to select
Connection open in the function menu.
Refer to Function and operation on the previous
page.
2 Press MULTI-CONTROL to open the con-
nection.
Always waiting flashes and the unit is now
on standby for connection from a cellular
phone.
3 Use cellular phone to connect to this
unit.
# PIN code is set to 0000 as the default. You
can change this code in the initial setting. Refer
to Entering PIN code for Bluetooth wireless con-
nection on page 31.

Disconnecting a cellular phone

1 Use MULTI-CONTROL to select
Disconnect phone in the function menu.
Refer to Function and operation on the previous
page.
Device name of the connected phone appears
in the display.
2 Press MULTI-CONTROL to disconnect a
cellular phone from this unit.
After disconnection is completed,
Disconnected is displayed.