GMC GM210S Mode D'emploi page 6

Introduction
Thank you for purchasing this GMC tool. This manual contains information necessary for safe and effective
operation of this product. This product has unique features and, even if you are familiar with similar products,
it is necessary to read this manual carefully to ensure you fully understand the instructions. Ensure all users of
the tool read and fully understand this manual.
Description of Symbols
The rating plate on your tool may show symbols. These represent important information about the product or
instructions on its use.
Wear hearing protection
Wear eye protection
GB
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Toxic fumes or gases!
DO NOT use in rain or damp environments!
Important safety devices! Ensure correct function, maintain in accordance with instructions and
DO NOT disable!
Dust extraction required or recommended
LASER warning!
Caution!
Class II construction (double insulated for additional protection)
WARNING: Moving parts can cause crush and cut injuries.
Be aware of kickback!
Environmental Protection Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local authority or retailer for
recycling advice.
Conforms to relevant legislation and safety standards.
378634_Z1PKGMANPRO1.indd 6
All manuals and user guides at all-guides.com
Original Instructions
6
Technical Abbreviations Key
V Volts
~, AC Alternating current
A, mA Ampere, milli-Amp
n No load speed
0
n Rated speed
λ
Wavelength
°
Degrees
Ø Diameter
Hz Hertz
, DC
Direct current
W, kW Watt, kilowatt
/min or min Operations per minute
-1
rpm
Revolutions per minute
nm Nanometre
dB(A) Decibel sound level (A weighted)
m/s
2 Metres per second squared (vibration magnitude)
Specification
Model no: GM210S
Voltage: 230-240V~ 50Hz
Power: 1800W
No load speed: 4800min
Max depth of cut: 60mm
Max blade size: Ø210mm
Bore: 25.4mm (1")
Supplied blade: Ø210mm x Ø25.4mm x 2.6mm x 24T
Mitre table angles: 0° to 45° left & right (0, 15, 22.5, 30 & 45° click stops)
Bevel cuts: 0° to 45° left
Straight cut: 0° mitre x 0° bevel 260 x 60mm
Mitre cut: 45° (L&R) x 0° 170 x 60mm
Bevel cut: 0° mitre x bevel (L) 45° 260 x 30mm
Compound cut: 45° bevel (L) x mitre 45° (R or L) 170 x 30mm
Ingress protection: IP20
Laser Class: II
Laser Wavelength: 400-700nm
Laser Output power: ≤1mW
Power cord length: 2 m
Protection class:
Weight: 14kg
As part of our ongoing product development, specifications of GMC products may alter without notice.
-1
26/10/2016 12:49