Uline METRO Serie Instructions De Montage page 2

2. Align holes on end of support bar with top of
end leg frame and center leg frame. Attach using
five M6 x 25 mm bolts (C). Repeat for remaining
three support bars. (See Figure 2)
Figure 2
End
Leg Frame
C
3. Place tabletops over assembled frame. Align
pre-drilled holes in tabletops with holes on
support bars. Attach using 12 M6 x 55 mm bolts (B).
(See Figure 3)
Figure 3
PAGE 2 OF 15
ASSEMBLY CONTINUED
Support
Bar
Center Leg
Frame
B
4. Attach bracket (E) to underside of tabletop
on the outside of center leg frame using eight
M6 x 15 mm bolts (D). Repeat for opposite side
of table. (See Figure 4)
Figure 4
NOTE: For powered tables, proceed to
Power Center Installation on page 5.
E
D
0123 IH-10276