Ryobi PCL540 Manuel D'utilisation page 6

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting through drywall.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
OPERATION
STARTING/STOPPING THE CUT-OUT TOOL
See Figure 1, page 9.
WARNING:
Always check that the spindle lock button is fully released
before switching on the tool.
 Install the battery pack as described later in this section.
 Hold the cut-out tool in front and away from you, keeping
the bit clear of the material.
 To start the cut-out tool, push the switch forward to the
ON position.
 To stop the cut-out tool, push the switch to the OFF
position.
LED WORK LIGHT
See Figure 1, page 9.
The LED work light illuminates when the cut-out tool is on.
WARNING:
Battery tools are always in operating condition. Make
sure the switch is in the OFF position when not in use
or carrying at your side, when installing or removing the
battery pack, and when installing or removing bits.
6 - English