Horizon Fitness T202 Manuel Du Propriétaire page 14

ASSEMBLY STEP 4
PART TYPE
A BOLT
B SPRING WASHER
C FLAT WASHER
(STEP 4.5)
5
1
14
HARDWARE FOR STEP 4
DESCRIPTION
M8X1.25PX15L
8.0X13.0X1.5T
8.2X13.0X1.4T
3
A
C
B
4
QTY
4
A
4
NOTE: Be careful not to pinch any wires while
4
assembling the console.
4.1 Open HARDWARE FOR STEP 4.
4.2 Gently place the CONSOLE (5) on top of the
CONSOLE MASTS (1&4). Attach the LEFT SIDE first
using 2 BOLTS (A), 2 SPRING WASHERS (B) and 2
FLAT WASHERS (C).
4.3 The CONSOLE CABLES (3) are tucked into the RIGHT
3
CONSOLE MAST (4). Using the lead wire carefully pull
the CONSOLE CABLE (3) out of the RIGHT CONSOLE
MAST (4). Detach and and discard the LEAD WIRE.
Connect the CONSOLE CABLES (3) and carefully tuck
wires in masts to avoid damage.
4.4 Attach the RIGHT SIDE of the CONSOLE (5) using
2 BOLTS (A), 2 SPRING WASHERS (B) and 2 FLAT
WASHERS (C).
4.5 Pull the top of the CONSOLE (5) towards the back of
the treadmill and HOLD while TIGHTENING THE LEFT
AND RIGHT SIDE BOLTS (A).
4.6 REMEMBER to tighten ALL BOLTS & SCREWS
completely now that assembly is finished.
B C