Publicité
Les langues disponibles
Les langues disponibles
PERFORMING A RECEPTION ATTEMPT
In order to perform a manual search for the radio signal (e.g. if you brought the
travel alarm clock to a different location), press the °C/°F button (6) for three
seconds.
This will start a new reception attempt. Then, as described above, wait for a few
minutes until the correct time is displayed.
SETTING THE TIME MANUALLY
If signal reception is not possible, the time can also be set manually. However, the
clock will continue to attempt detection of signal several times a day and and sets
the received time after successful detection of a signal.
-
Hold the MODE button (2) pressed for about two seconds until the region display
fl ashes.
-
Use the ADJUST button (3) to select the region where you are:
-
Press the MODE button (2) again and set the language for display of the week-
days using the ADJUST button (3):
-
Proceed as described above in order to set the DST function, the hour/minute/
second/year/month/date and date formate display.
-
Press the MODE (2) button again or wait for 30 seconds to save your settings.
TIME ZONE (ONLY FOR WWVB RECEPTION)
There are four time zones for the display of the time in the USA.
-
Press the MODE button (2) and set the desired time zone using the ADJUST but-
ton (3):
P=Pacifi c (default setting)/M=Mountain/C=Central/E=Eastern
-
Press the MODE button (2) again or wait for 30 seconds to save your settings.
DISPLAY LIGHT
-
Press the SNOOZE/LIGHTbutton (4) to turn on the display backlight for a few
seconds.
TEMPERATURE UNIT
-
Press the °C/°F button (6) briefl y to toggle the unit for the temperature display.
ALARM FUNCTION
Setting the alarm:
-
Press the MODE button (2) briefl ly to select the alarm display.
-
Hold the MODE button (2) pressed for two seconds until the hour display of the
alarm time fl ashes.
-
Set the hours for the alarm time using the ADJUST button (3).
-
Press the MODE button (2) again and set the minutes for the alarm time using
the ADJUST button (3).
-
Press the MODE button (2) three times or wait for 30 seconds to save your set-
tings and return to the normal display.
The alarm function is activated automatically after making these settings.
-
-
Press the MODE button (2) in normal operation once to display the alarm.
Alarm modes:
-
Press the ALARM button (5) until the desired function is shown in the display (1):
No symbol = alarm function off
Bell symbol = normal alarm function
Bell symbol with "Zz" = alarm function with snooze
-
The alarm sounds at the set alarm time, if the alarm function is activated.
-
If the normal alarm function was selected, switch off the alarm by pressing the
ALARM button (5) or the SNOOZE/LIGHT button (4). The alarm will sound at the
same time the following day.
-
If the alarm function with snooze was selected, switch off the alarm until the
next day by pressing the ALARM button (5) as described above or press the
SNOOZE/LIGHT button (4) to activate the snooze function.
Snooze function:
-
The alarm is repeated up to 13 times in 5-minute intervals. The alarm sounds for
1 minutes.
-
In order to switch off the alarm until the next day, press the ALARM button (5).
All manuals and user guides at all-guides.com
SECOND TIME ZONE
The radio-controlled travel alarm clock can also display the time of a timezone.
-
-
-
-
-
LOCATION
Select an even, fl at and stable installation location. Protect valuable furniture
surfaces by using an appropriate underlay otherwise scratch marks can occur.
Fold out the stand (8) and position the travel alarm clock so that it cannot fall down.
To ensure correct radio signal reception, the radio-controlled travel alarm clock
should not be placed next to electronic devices, cables, metal parts and so on.
MAINTENANCE AND CLEANING
Apart from replacing the batteries, the product does not require any maintenance
and should never be disassembled.
Please use a soft, dry, clean cloth for cleaning.
Do not use aggressive detergents as these can cause discoloration of the case.
DISPOSAL
a) Product
b) Batteries and Rechargeable Batteries
The end user is legally obliged (Battery Regulation) to return used batteries and
rechargeable batteries. Do not dispose of used batteries in the household waste!
You can dispose of your used batteries/rechargeable batteries free of charge at your
community's collection point or any place where batteries/rechargeable batteries
are sold!
You thereby fulfi l your statutory obligations and contribute to the protection of the
environment.
DECLARATION OF CONFORMITY (DOC)
The manufacturer hereby declares that this product conforms to the fundamental
requirements and the other relevant regulations of Directive 1999/5/EC.
TECHNICAL DATA
Operating voltage: ........................................................... 3 V/DC
Battery: .............................................................................. 3 V Lithium button cell CR2023
Battery life: ....................................................................... approx. 2 years
Measuring range of thermometer ................................ -25 to +65 °C
Thermometer resolution: ............................................... 0.1°C
Dimensions: ...................................................................... 88 x 60 x 19.5 mm
Weight: ............................................................................... 71 g
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by
any method, e.g. photocopy, microfi lming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. These ope-
rating instructions represent the technical status at the time of printing. Changes in technology
and equipment reserved.
© Copyright 2011 by Conrad Electronic SE.
Press the MODE button (2) twice and DUAL TIME will be shown in the display.
Hold the MODE button (2) pressed for two seconds until the HR display
appears.
Set the time difference to the current time using the ADJUST button (3). The
setting range is +/- 23.
Press the MODE button (2) twice or wait for 30 seconds to save your settings and
return to the normal display.
Press the MODE button (2) in normal operation twice to display the time of the
2nd timezone.
Electronic devices are recyclable waste materials and must not be disposed
of in the household waste!
Please dispose of the product, when it is no longer of use, according to the
current statutory requirements.
Remove any inserted battery and dispose of it separately from the product.
Contaminated batteries/rechargeable batteries are labelled with these sym-
bols to indicate that disposal in the domestic waste is forbidden. The sym-
bols for the relevant heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead
(marking can be seen on the battery/rechargeable battery, e.g., underneath
the refuse bin symbol shown on the left).
You can fi nd the Declaration of Conformity for this product at
www.conrad.com.
Publicité
