Beta 1471PN/50 Mode D'emploi page 4

Beta
Pneumatic tool for rotating and pushing back brake pistons
ATTENTION
Always follow the instructions provided by the vehicle manufacturer. For use by trained
personnel only.
To maintain an acceptable noise level, do not exceed 8 bar pressure.
The tool is designed to be used with 5-8 bar pressure.
How to Use
1. Choose an adapter suitable for working on the brake caliper piston. Fit it onto magnetic
end (1). Connect the tool to the compressed air line, making sure that it does not exceed 8 bar
pressure.
2. Press release button (2) and operate lever (3) to move the push rod forward or backward and
fit the tool into the caliper.
3. Press button (4), while rotating lever (3), to rotate the brake caliper piston.
4. After pushing the piston backward, press button (2) and pull lever (3) to move the push rod
backward, releasing the tool from the caliper.
Information on adapters:
0 GM
2 Citroën, Honda
3 VW, Land Rover
4 Alfa Romeo, FIAT, FORD, GM, HONDA, MAZDA, SAAB, TOYOTA,
5 3/8" adapter
6 NISSAN, VW
7 Alfa Romeo, Audi, Citroën, FIAT, FORD, HONDA, Jaguar, Lancia, NISSAN, PEUGEOT,
Renault, Rover, SAAB, Seat, SUBARU, TOYOTA, VW, Volvo
8 GM
9 GM
A Renault
M FORD, MINI
N Alfa Romeo, Audi, Lancia, SAAB, Honda, VW
E FORD, NISSAN
F Opel
K Citroën
WARRANTY
We accept no responsibility for damage caused by misuse or any use that is not in compliance
with the safety standards described herein.
INSTRUCTIONS
ART. 1471 PN/50
GB