Glow Fire 106 Instructions De Montage page 11

Touch-on Control Panel
Touch-on Control Panel Operation
BUTTON
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
POWER
COLOR button: Makes the color flame effect
changing.
NOTE: color effect stays on until power button
is turned off. Color flame effect must be on for
COLOR
heater to turn on.
TIMER button: Controls timer settings to turn
off fireplace at selected time.
Settings range from 0.5 hours to 8 hours.
TIMER
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: Heater button can be locked or
unlocked by holding the Heater button for 5
HEATER
seconds.
Remote Control Operation
BUTTON
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
POWER
TIMER button: Controls timer settings to turn
off fireplace at selected time.
Settings range from 0.5 hours to 8 hours.
TIMER
Glow Fire GmbH, James-Franck-Straße 23, 12489 Berlin
FUNCTION
FUNCTION
Remote control
ACTION & INDICATION
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit
goes to standby. All functions turn off.
1. Press once. Flame color effect gets
changing.
2. Press again until desired setting is reached.
In total with 10 color flames.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is
reached.
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to
allow heater to cool down, then turns off.
ACTION & INDICATION
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit
goes to standby. All functions turn off.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is
reached. Indicator lights show setting.
11