Thermador Professional PRO HARMONY PRD30 Manuel D'installation page 21

Keep Hot Shelf
(KHS [30, 36, 42, 48] QS)
Edge wilt slide
beneath hood
,\
\
\
\
\\
\
"%,\
\\
\\\
X 137/8
\\ (352mm
\
\\
\
\
'X
\
,\
\
\
Items Included
12 - 1" (25.4mm) screws
4 - ½" (12.7mm) screws
#,
4 - U-Nuts
2 - Top shelf brackets
4 - Lower shelf brackets
2 - Keep hot racks
1 - Keep hot shelf backsplash
1 - Installation guide & template
Figure 18: Keep Hot Shelf
Tools Needed
Tape measure
Phillips screwdriver or drill
Painter's Tape
Sharp knife or scissors
Pencil
,
Tape the templates included with the Keep Hot Shelf to
the wall accordingly:
• Tape the sheet titled Left Hand Template to bottom
and left end of hood. Align the bottom line of hood
with the top line of the template.
• Tape the sheet titled Riqht Hand Template to
bottom and right end of hood. Align the bottom line
of hood with the top line of the template.
• Tape the sheet titled Installation Instruction so that
the arrow at the top of the template aligns with
hood centerline. Align the bottom line of the hood
with the top line of the template.
• Left to right sides of the template must be equal to
length of shelf.
English 19