IMS GOLD MULTI 140 Mode D'emploi page 20

Translation of the original instructions
Additional pre-
cautions
People wearing Pacemakers are advised to see their doctor before using this device.
Handle gas bottles with care - there is increased danger if the bottle or its valve are damaged.
TROUBLESHOOTING
SYMPTOMS
The welding wire speed is
not constant.
The wire-feeder motor
doesn't operate.
Bad wire feeding.
No welding current
The wire jams (after the
rollers)
20
IMS GOLD MULTI 140
Any welding operation undertaken in precautions
- Rooms where there is an increased risk of electric shocks,
- Poorly ventilated rooms,
- In the presence of flammable or explosive material, should always be approved by a
«responsible expert», and made in presence of people trained to intervene in case of
emergency.
Technical protection as described in the Technical Specification CEI/IEC 62081 must
be implemented. Welding in raised positions is forbidden, except in case of safety
platforms use.
Do not use the welding unit to unfreeze pipes.
POSSIBLE CAUSES
Debris is blocking up the opening.
The wire skids in the rollers.
Reel or roller brake too tight.
Electrical supply problem.
Covering wire guide dirty or damaged.
The drive roller is too loose
Reel brake too tight
Bad connection to the main supply.
Bad earth connection.
Torch trigger inoperative.
Guide wire sheath crushed.
Wire jammed in the torch
No capillary tube.
Wire speed too fast
REMEDIES
Clean out the contact batch or change it
and replace the anti-adherence product.
Ref.041806.
• Control the roller pressure or replace it.
• Wire diameter non-compatible with roller
• Covering wire guide in the torch
non-compatible."
Release the brake and rollers.
Check that the power switch is in the "On"
position.
Clean or replace
Tighten the drive roller knob
Release the brake
Check the mains connection and look
if the plug is fed by 230 V (1PH) power
socket.
Check the earth cable (connection and
clamp condition).
Check the torch trigger / replace torch
Check the sheath and torch body.
Clean or replace.
Check the presence of capillary tube.
Reduce the wire speed
EN