Invacare Cruiser Plus Guide D'utilisation page 11

Les langues disponibles

Footplate Height/Angle

As tools are required, adjustments to suit your needs should only be made by your INVACARE supplier/dealer

prior to delivery/collection. If adjustments are required at a later date contact your dealer who would be

pleased to assist you.

Note

The following adjustments should be made by an assistant while you are seated in the Powerchair.

Armrest Height

Loosen the thumb screw in the vertical armrest support tube and pull or push the armrest up or down to

the desired height. Re-tighten the thumb screw.

Joystick Position

The Joystick Box should be in a position where the drive controls are within easy reach. If required,

slacken the thumb screw in the horizontal joystick box support tube and slide the joystick box forward or

rearward to the desired position. To adjust the height loosen the thumb screw in its vertical mounting

tube and pull or push the Joystick Box, together with its horizontal support, up or down. Re-tighten the

thumb screw(s).

Seat Width

The seat width is adjusted by reducing or increasing the distance between the armrests/side panels (refer

to General Specification Data for adjustment range). Slacken the screw at the bottom end of the

armrests/side panel mounting socket and slide the armrest/side panel inward

or outward to the desired position. Re-tighten the screw(s). This adjustment

may, of course, be made either on both sides or on one side only.

Tension Adjustable Backrest - Adjustment

Unique to the CRUISER plus Powerchair is the ergonomically designed

Tension Adjustable Backrest, a fully adjustable back upholstery system that

can be adjusted to suit the users back profile.

With the user seated and parking brakes on, release and lift the

backrest rear cover panel (Fig. 7.1) up and clear of the tension

straps (Fig. 7.2).

Release all the tension straps from their fasteners (Fig. 8.1).

With the user leaning back adjust the tension straps allowing

them to self adjust to the users profile.

With the user continuing to lean back tighten and secure

the tension straps ensuring that they are not overtightened.

Lower the rear cover panel and secure into position.

Check that the user is comfortable, re-adjust if required.

Accessories Including Seat Belt Attachment

If included with your purchase of your Powerchair, these will have been factory

fitted or by your INVACARE supplier/dealer, who would have provided you

with a demonstration of operation and fitting etc.

Fig. 7

Fig. 8