Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1. ALWAYS turn on your transmitter before you turn on the receiver in the vehicle. ALWAYS power off the receiver before turning
your transmitter off.
2. ALWAYS operate your vehicle in a wide open arena.
Operating the vehicle on slipery floor or indoors may crash
because of the high speed.
4. ALWAYS start with low speed, or the vehicle may slip or run on curves. (as shown on Pic 1 ) NEVER operate your vehicle in max
speed. Operating the vehicle in highest speed may hurt yourself and damage your vehicle.
MOTOR CARE
• Seat the motor brushes by driving smoothly on a flat surface during use of the first battery charge. Failing to do so can greatly
reduce motor performance and functional life.
• Prolong motor life by preventing overheating conditions. Undue motor wear results from frequent turns, stops and starts,
pushing objects, driving in deep water and tall grass, and driving continuously up hill.
TROUBLESHOOTING
Problem
Short run time
Sluggish action
Do not operate
Poor range
The system will not
Connect
The receiver quits
responding
During operation
Receiver loses
its bind
Possible Cause
• Battery damaged/not charged
• Motor dirty or brushes worn
• Motor dirty or brushes worn
• Bind in drivetrain
• Vehicle battery is not charged
• Transmitter batteries low
• Transmitter powered off
• Vehicle battery is not charged
• Low transmitter batteries
• Receiver antenna damaged
• Transmitter and receiver too near
each other
• Transmitter and receiver too near
large metal objects (vehicles, etc.)
• Receiver accidentally put in bind
mode so receiver is no longer bound
• Low battery voltage
• Transmitter accidentally put in bind
mode, ending bind to receiver
- 4 -
3. WARNING: 9130 waterproof feature, please be cautious
that the water level should be lower than the bottom of the
truck. If excessive amount of water gets into the body of the
truck and cause damage or other related problems, we will
not be responsible for such damages. Customers will be res-
ponsible for any replacements and additional accessories if
needed.
• Check/change battery
• Check/clean/replace
• Check/clean/replace
• Clean/adjust
• Replace/recharge
• Replace/recharge
• Power On
• Replace/recharge
• Replace/recharge
• Check/repair/replace
• Move transmitter 8–12 feet
(2.4–3.6m) from receiver
• Move away from large metal
objects (vehicles, etc.)
• Rebind transmitter and
receiver
• Completely recharge battery
• Bind transmitter to receiver
Solution
Publicité
