Publicité
Les langues disponibles
Les langues disponibles
4
IF NECESSARY ADJUST LATCH INSTALLATIONS FOR PROPER BACKSET
BACKSET
2-3/8" (60 mm)
or
2-3/4" (70 mm)
DEADBOLT
1
2
3
HANDLESET
SPINDLE
Insert Handleset Spindle for
2-3/4" Backset
2-3/8" Backset
(FOR SINGLE CYLINDER FUNCTION) INSTALL OUTSIDE
7
CYLINDER HOUSING AND INTERIOR THUMBTURN
Install outside cylinder, and thumbturn
Deadbolt spindle in horizontal position
5
INSTALL HANDLESET LATCH AND DEADBOLT
• Place sleeve over handleset latch before installation in square
corner or radius corner mortise configuration
• Do not use sleeve for installations in drive-in configuration
For 2-3/4"
(70 mm)
INSTALL STRIKES
8
Install strikes onto door jamb.
High Security Double Strike
3" (76 mm) Screws
OR
Reinforcement Plate
6
INSTALL HANDLESET, INSIDE LEVER OR KNOB
Install Handleset
SLEEVE
Tap latch flush
1. Outside Cylinder
2. Deadbolt Latch
1
3. Thumbturn
Install Inside Knob or Lever
4. 2-5/8" (66 mm) Deadbolt Screws (2)
15. 1-1/4" (32 mm) Strike Screws (4)
6. 3" (76 mm) Reinforcement Screws (2)
7. High Security Deadbolt Strike
1
8. 1-1/2" (38 mm) Dome Head Knob
Screws (2)
OR
EXTERIOR
19. Inside Knob or Lever
10. 3/4" (19 mm) Latch Screws (4)
11. Rounded Corner Faceplate
12. Handleset
13. Handleset Latch
14. Latch Strike
15. Screw Cap
16. 1-5/8" (42 mm) Handleset Post Screw (1)
17. Washer
18. 2-Piece Drive-In Collar for Deadbolt Latch
19. 2-Piece Drive-In Collar for Handleset Latch
INTERIOR
H26-J000J12
REV. SEPTEMBER, 2016-01
Publicité
