Taymor ASHFORD Instructions D'installation

INSTALLATION INSTRUCTIONS
ASHFORD
TOOLS AND MATERIALS REQUIRED
> Drill
> 2-1/8" (54 mm) Hole Saw > Chisel
> 3/8" (10 mm) Drill Bit > Phillips Screw Driver
> 1" (25 mm) Wood Bit > Tape Measure
1
DETERMINE DOOR HANDING
Stand at the exterior side and face the door.
A. Your door is a LEFT HAND door if hinges
are installed at your left hand.
B. Your door is a RIGHT HAND door if hinges
are installed at your right hand.
A. B.
LEFT RIGHT
HANDING HANDING
HINGES
HINGES
✁
CENTER TO CENTER
2a USE THROUGHBOLT TEMPLATE TO MARK
AND DRILL HOLES
1. MARK DOOR
2. DRILL HOLES
Use template attached to mark
Select backset. Mark and drill
holes on door face.
holes as shown.
A. Make mark for 1"(25 mm) hole
on door edge.
B. Height 36" (914 mm) to 38"
(965 mm) from floor.
1"
(25 mm)
2-1/8"
(54 mm)
3/8"
(10 mm)
5-1/2" (140 mm)
2b IF REPLACING EXISTING HANDLESET OR INSTALLING ON PRE-DRILLED
DOOR, CHECK DOOR JAMB AND DOOR PREPARATION
Backset
2-3/8" (60 mm)
or
2-3/4" (70 mm)
2-1/8"
(54 mm)
1" (25 mm)
5-1/2"
(140mm)
OR
1" (25 mm) or 7/8" (22 mm)
2-1/8"
(54 mm)
OR
9-11/16" (246 mm)
3/8"
(10 mm)
Chisel outlines for strike plates until they sit
flush with door edge.
Mark Height 36" (914 mm) from Floor to Center
9-11/16" (246 mm)
CENTER TO CENTER
CARE AND MAINTENANCE
The following care instructions should be followed to ensure a long lasting finish:
1. Remove locks, or do not install locks, prior to painting your door.
2. Periodically clean with mild soap and a soft cloth only.
3. Do not use abrasives or harsh chemicals
3 CHOOSE LATCH FACE PLATE FOR HANDLESET & DEADBOLT
RADIUS OR SQUARE CORNER
MORTISE
1-1/2" (38 mm) High
1" (25 mm) Wide
1-3/16" (30 mm ) Deep
1" (25 mm) Radius
5/16" (8 mm) Deep
Chisel 1/8" (3 mm) deep or until
latch face plate is flush with door
edge.
DRIVE-IN
1
2
3
REV. SEPTEMBER, 2016-01
taymor.com