Controls And Functions; Receiver (R-840) - Yamaha MCR-640 Mode D'emploi

CONTROLS AND FUNCTIONS

Receiver (R-840)

■ Front panel
1 2 3 4
INPUT
PRESET
TIMER
BASS
PHONES
@ A BC
1 INPUT
Selects an input source.
2 On/Standby indicator
Lights up in green when the receiver is turned on. Lights
up in amber when the receiver is in standby mode.
3 Remote control sensor
Receives signals from the remote control.
4 PRESET indicator
Lights up when you select preset radio stations (☞p.19).
5 TUNED indicator
Lights up when the receiver is tuned into a station.
6 STEREO indicator
Lights up when the receiver is receiving a strong signal
from an FM stereo broadcast.
7 SLEEP indicator
Lights up when the sleep timer is on (☞p.21).
8 Front panel display
Shows the various information such as the tuning
frequency.
9 VOLUME
Adjusts the volume level.
0
(On/Standby)
Turns the receiver on or sets it to standby mode.
A PHONES jack
Outputs audio signals for private listening with
headphones.
4
En
CONTROLS AND FUNCTIONS
567 8
VOLUME
TUNED STEREO kHz SLEEP MHz
MIN MAX
TREBLE BALANCE
PRESET PURE DIRECT
L R
D E F G
Front view
9
B TIMER indicator
Lights up when the timer is set (☞p.20).
C BASS
Adjusts the low frequency response (☞p.13).
D TREBLE
Adjusts the high frequency response (☞p.13).
E BALANCE
Adjusts the audio output balance of the left to right
speakers to compensate for imbalances caused by speaker
locations or listening room conditions.
F PRESET d / u
Selects a preset station. The input source is changed to
FM. Operable even when the receiver is in standby mode
(☞p.19).
G PURE DIRECT
Turns on or off Pure Direct mode (☞p.13).
When Pure Direct mode is on, the indicator lights up in
blue.
H h / e
Starts and pauses the playback of iPod. The input source is
changed to iPod. Operable even when the receiver is in
standby mode.
I iPod dock
Connect your iPod (☞p.10).
iPod
H I
Top view