Regalo 1250 Mode D'emploi page 6

STEP 2
Once the 2 1/2" maximum gap is set, tighten
down the 4 jam nuts with a 13mm wrench.
One on each hinge adjustment knob and one
on each receiver adjuster knob.
Replacement Parts
A
Hardware Kit #13255 Includes:
Hardware Kit
B
Hardware Kit #11255 Includes:
Hardware Kit
All manuals and user guides at all-guides.com
STEP 3
Install the wall mount hinge snap female over the
wall mount hinge snap male. Do so by matching
the "legs" of the wall mount hinge snap female
over the grooves, and sliding down until it clicks
into place of the wall mount hinge snap male (C).
To remove hinge snap, with two fingers, gently pull
both legs outward and slide hinge snap upward.
• Coupler, Male
• Coupler, Female
• Mount, Wall, Latch, Snap, Female
• Mount, Wall, Hinge,Snap, Female
• Lower, Mount, Wall, Hinge
• Latch, Assembly, Mount, Wall
• Coupler, Male
• Coupler, Female
• Mount, Wall, Latch, Snap, Female
• Mount, Wall, Hinge,Snap, Female
• Lower, Mount, Wall, Hinge
• Latch, Assembly, Mount, Wall
• Lower, Mount, Wall
• Bolt, Elevator, Overmolded
• M8 x 1.25 Nut
• Screw, Wood, M4 x 50MM (equivalent
is No 8 Wood Screw x 2" long)
• Hinge Adjuster Knob
• Lower, Mount, Wall
• Bolt, Elevator, Overmolded
• M8 x 1.25 Nut
• Screw, Wood, M4 x 50MM (equivalent
is No 8 Wood Screw x 2" long)
• Hinge Adjuster Knob
STEP 4
To open the gate. Rotate the latch of the latch
assembly wall mount in the clockwise
direction to release the gate. Lift the gate
upward and away from the stairs. Pivot the
gate in the hinges until fully open.
90 DAYS LIMITED
WARRANTY
If, during the first 90 days after
consumer purchase of the
item, under reasonable and
non-commercial use and
conditions of maintenance, it
fails while owned by the
original purchaser because of
the quality of materials or
workmanship of finish and
assembly, Regalo
International, LLC, will replace
or repair it at Regalo's option.
PROOF OF PURCHASE
REQUIRED.