Regalo 1250 Mode D'emploi page 4

Hinge Placement
STEP 1
STUD
DRYWALL
6" MIN.
1 1/2" MAX.
STAIRS/FLOOR
The hinges get installed on the right side of
the stairs (when looking down the stairs).
Using a stud finder locate a stud in the wall
that is at a minimum 6" from the edge of the
top stair. Once the stud is located, place the
lower mount wall hinge (E) against the wall.
Position it so the lower hole of the lower
mount wall hinge is at a maximum of 1 1/2"
above your floor.
Gate Assembly
STEP 1
Screw the top hinge adjuster knob (G) into the
main gate panel (A). Repeat with the lower
knob as well. Rotating the hinge in the
clockwise direction will bring the hinge in.
Loosen the jam nut all the way back.
All manuals and user guides at all-guides.com
STEP 2
Using the supplied 2" wood screws (I), screw
through the lower mount wall hinge into the
drywall and stud. Do this for the top and bottom
hole.
STEP 2
Screw the top receiver adjustment knob (H)
into the second gate panel. Repeat with the
lower knob as well. Rotating the receiver in
the clockwise direction will bring the receiver
in. Loosen the jam nut all the way back.
STUD
DRYWALL
STAIRS/FLOOR
Repeat with the wall mount hinge snap female
(B). The distance between the top hole of the
lower mount wall hinge and the lower hole of the
wall mount hinge snap female is 25".
Place the main gate panel with the hinge adjuster
knobs into the upper and lower hinges on the
wall. Press the main gate panel in a downward
motion to set the hinge adjuster knobs into the
hinges.
STEP 3
STUD
DRYWALL
25"
STAIRS/FLOOR
STEP 3
(SHOWING MAIN GATE
PANEL SET IN THE HINGE)