Parts Identification; Before First Use; How To Use - Hkoenig GR20 Manuel D'utilisation

PARTS IDENTIFICATION

BEFORE FIRST USE

• Read all instructions carefully and keep them for future reference.
• Remove all packaging
• Clean the Cooking Plates by wiping a sponge or cloth dampened in warm water.
DO NOT IMMERSE THE UNIT AND DO NOT RUN WATER DIRECTLY ONT THE COOKING
SURFACES.
• Dry with a cloth or paper towel.
• For best results, lightly coat the cooking plates with a little cooking oil or cooking spray.
Notice: When your Grill Toaster is heated for the first time, it may emit slight smoke or odor.
This is normal with many heating appliances. This does not affect the safety of your appliance.

HOW TO USE

• Set the Grill Toaster Temperature Control to your desired
setting. At first, try a setting in the max.
You may later adjust it lower or higher according to your
preference.
• Close the Grill Toaster and plug it into the wall outlet, you
will notice that the power and ready light will come on,
indicating that the Grill Toaster has begun preheating.
• It will take approximately 5 minutes to reach baking
temperature, the ready light will goes off.
• Open the Grill Toaster, put the sandwich, meat or other foods on the bottom cooking plate.
• Close the Grill Toaster. The ready light will go on again.
• Cook for about 3 to 8 minutes, the ready light goes off again, or until golden brown, adjusting the
time to suit your own individual taste.
• When the foods is cooked use the handle to open the lid. Remove the foods with the help of a
plastic spatula. Never use metal tongs or a knife as these can cause damage to the non-stick
coating of the cook plates.
• Once you are finished cooking, disconnect the plug from the wall outlet and leave unit open to
cool.
1. Handle
2. Upper Housing
3. Hinge Release Lever
4. Upper Non-stick Plate
5. Bottom Non-stick Plate
6. Ready Light (Green)
7. Power Light (Red)
8. Thermostat Knob
9. Bottom Housing
10. Oil Tray