Publicité
Les langues disponibles
Les langues disponibles
HRV INSTALLATION
• Have a nearby power sup-
ply (120 volts, 60Hz)
• Choose a location which
allows the possibility of
mounting the unit to sup-
porting beams.
• The unit should be level
in order to allow proper
condensate drainage
• To minimize noise, do not
install unit in living area
• Ensure proper drainage
MOUNTING – WALL MOUNT
1. Attach bracket to wall
2.
Lift unit & slide nuts into slots on bracket
3. Tighten screws to secure unit to bracket
4. Ensert the safety screws & place wall bumpers to level off the unit.
*Optional chain hanging kit available.
INSTALLING DRAIN LINE
Through normal operation and during its defrost mode, the HRV may produce
some condensation. This water should flow into a nearby drain, or be taken away by a condensate pump. The HRV and all condensate
lines must be installed in a space where the temperature is maintained above the freezing point. A "P" trap should be made in the drain
line. This will prevent odors from being drawn back up into the unit.
1 Install the drain nipple.
10
All manuals and user guides at all-guides.com
LOCATION
The HRV must be located in a heated space where it will be possible to conveniently service the unit.
Typically the HRV would be located in the mechanical room or an area close to the outside wall where
the weatherhoods will be mounted. If a basement area is not convenient or does not exist, a utility
room may be used.
Attic installations are not normally recommended due to:
• The complexity of the installation
• Freezing conditions in the attic
• Difficulty of access for service and cleaning
• No drain access
Connecting appliances to the HRV is not recommended. These include:
• Clothes dryer
• Range top
• Stovetop fan
• Central vacuum system
• Bathroom exhaust fans unless they are specifically designed for this purpose
These appliances may cause lint, dust or grease to collect in the HRV, damaging the unit.
Connecting any of
these types of
appliances to the
HRV will void your
warranty.
2 Install the drain hose,
making a "P" trap
Safety screws
(included)
Place bumpers on
back of unit
(included)
Publicité
