Siemens TJ10 500 Mode D'emploi page 34

Technical service
Should your appliance fail to work properly
and all the instructions for use and installation
(especially the section headed
"Requirements....") have been carefully
observed, then remember that our Technical
Service Network is at your full disposal.
When contacting the Technical Service, quote
the model code (E-NR) and the appliance's
factory number (FD). This information can be
found on the characteristics plate, 19, Fig. 2.
Electrical connection .......................................230 V, 10 A/16 A
Heat power .............................................................10 A: 2150 W
................................................................................16 A: 3400 W
Air flow during ironing: ...................................approx. 250 m
Measurements of the main body:
Technical service and Warranty
Technical Data
Height:..........................................................................1,73 m
Height, lowered:...........................................................1,20 m
Width:...........................................................................0,37 m
Depth:...........................................................................0,51 m
Weight:..............................................................approx. 26 kg
Warranty
The conditions of warranty depend on the
relevant Supplier in a particular country.
Contact the establishment where you
purchased your appliance for more information
and quote the appliance model and factory
number. The receipt of purchase for the
appliance must be produced prior to any work
carried out under warranty.
34
/h
3