Siemens TJ10 500 Mode D'emploi page 29

❏ Remove the aired garment from the ironing
dummy.
❏ The next garment can now be fitted onto
the appliance.
Turning off the shirt ironer
❏ Turn the programme selector switch to "0".
❏ Turn the shirt ironer off by pressing
❏ Turn lifting knob 1, Fig. 1 anti-clockwise
while gripping the button band with the
other hand and pull it downwards. The
button band starts lowering.
Warning!
The shirt ironer may suffer damage. Make
sure that all the flaps are closed before
lowering the upper frame.
Make sure the ironing dummy and/or the
adjustment cords do not get hooked up.
❏ Lower the appliance completely by pushing
the casing down until the upper part clicks
into its down position.
Use
Storing your shirt ironer
There are two cable supports on the back of
the shirt ironer. 17, Fig. 2.
❏ Wind the mains cable onto the wind pillar.
Secure the plug in position.
❏ Take one of the cuff adjusters, fold the
inflatable sleeve and insert the adjuster
between the size adjustment cords so that
.
the cuff adjuster remains in a vertical
position. Repeat the process with the other
sleeve.
❏ Fit the cover appliance over the top of the
shirt ironer. The pocket goes on the back.
❏ Fit the rubber tightener on the cover
appliance into the guide on the lower frame
of the shirt ironer.
❏ To transport the ironer, hold the handle 10
Fig. 2 and tilt the appliance backwards.
Transport the shirt ironer fully lowered to
the place where you wish to store it!
29