Siemens TJ10 500 Mode D'emploi page 26

Warning!
The Ironer must be fully lowered for
transportation!
❏ Put the shirt ironer in position.
❏ Turn lifting knob 1, Fig. 1, anti-clockwise
while gripping the button band, 8, Fig. 2,
with the other hand and pull it upwards.
Warning!
On releasing the lifting knob and pulling
the button band upwards, the appliance
rises to a specific height. Do not place
anything on top of the appliance during
this process!
❏ Grip the button band with both hands and
finish lifting the top 8, Fig. 2 part of the
appliance until you hear a click, which
indicates that it has reached its limit. Fig. 4.
❏ Plug it in.
For safety reasons, ironing and/or airing
can only be started when the upper frame
is completely raised.
The light flashes 10 times when the
lifted appliance is connected to the
electricity supply or when it is lifted from
its down position when already connected.
The light flashes to remind you to press
the button. Pressing the button initiates
preheating and thereby reduces drying
time.
Ironing
❏ Turn the collar adjuster knob 7, Fig. 2 to its
vertical position.
❏ Open all the flaps on the button band
adjuster and the collar support.
Fitting the shirt
❏ Unbutton the shirt and the cuffs.
❏ Lift the collar.
❏ Fit the damp, spin-dried shirt onto the
ironing dummy.
❏ Fit one arm of the ironing dummy inside the
shirtsleeve. Do not twist the sleeves, Fig. 5.
❏ Place the other arm of the ironing dummy
into the other shirtsleeve. Do not twist the
sleeves.
Use
❏ The arrows shown in the picture indicate the
lower seam. Fig. 6.
❏ Line the lower hem up with the line marked
on the plastic part at the top of the button
band, Fig. 7
❏ Hold the collar flaps firmly and close the two
top flaps on the button band adjuster,
Fig. 8.
❏ Pull the button band on the shirt down and
fit it vertically onto the button band adjuster.
To avoid marking of any kind, do not insert
the button band too much. Position the
button band in such a way that the
perforated plate is completely covered.
❏ Starting at the top, close all the flaps on the
button band adjuster. Secure the button
band firmly in place. Close those flaps not
required to hold the shirt in place as well.
❏ Repeat this proceeding to tighten the other
side of the shirt.
❏ Turn the collar adjuster knob clockwise from
its vertical position while adapting the back
of the collar to the Ironer by pulling it gently
upwards with the other hand.
❏ Close the two upper supports on the casing
to maintain the shirt collar up. Correct the
positioning of the back of the shirt by pulling
it lightly upwards.
A spring adapts the collar adjuster to the
size of the shirt collar. The rotated position
of the knob depends on the size of the
shirt.
Do not overturn the knob when turning it
clockwise. The knob sets itself in the right
position.
Do not adjust the knob when the appliance
is inflated.
26