Black & Decker PRO Serie Mode D'emploi page 12

ENGLISH
Installing a New Saw Blade
(UNPLUG THE MITRE SAW)
• DO NOT USE FERROUS METAL or masonry cutting
blades in this saw
• Loosen hex bolt on center cover counter clockwise with
box wrench.
• Lift up the safe cover and center cover.
• Press down the lock to lock spindle.
• Loosen hex bolt clockwise with box wrench, then
dismount the bolt and flange.
• Mount the blade of saw on spindle. Make sure that the
arrow direction on surface of saw blade is same as one
of the cover.
Note: There are two different internal diameters of cutter in
inner plate which have steel stamp marked 25.4mm 16mm.
When mounting, the outer diameter of inner plate must be
correspondent with the internal diameter of saw blade.
• Mount flange and hex bolt.
• Press axle lock and tighten hex bolt counter clock wise
with box wrench firmly, then tighten hex bolt clockwise to
fix centre cover.
Note: Only use attached wrench when mounting or
dismounting saw blade. When dismounting saw blade, lift up
safe cover and centre cover. Loosen hex bolt with box
wrench and disassemble hex bolt, flange and saw blade.
NEVER DEPRESS THE SPINDLE LOCK PIN WHILE THE
BLADE IS ROTATING.
• Be sure to hold the guard bracket down and firmly
tighten the guard bracket screw when you finish
installing the saw blade. Failure to do so will cause
serious damage to the saw.
Specifications
Power
No-Load speed
Max Depth
12
All manuals and user guides at all-guides.com
Troubleshooting
Trouble! Saw makes unsatisfactory cuts
What's wrong?
3. Gum or pitch on blade.
4. Incorrect blade for work
Trouble! blade does not come up to speed
What's wrong?
1. Extension cord is too light 1. Replace with adequate
2. Low house current.
Trouble! Machine vibrates excessively
What's wrong?
1. Saw not mounted securely. 1. Tighten all mounting
2. Stand or bench on
3. Damaged saw blade.
1. mitre scale not adjusted
2. Blade is not square to
3. The disc is perpendicular 3. Check and adjust the
4. Workpiece moving.
Trouble! Material pinches blade
1500W
What's wrong?
5500/min
1. Cutting bowed material.
70mm
What to do
3 Remove blade and
4. Change the blade.
being done.
What to do
or too long.
2. Contact your electric
What to do
2. Reposition on flat level
uneven floor.
3. Replace blade.
1. Check and adjust.
correctly.
2. Check and adjust.
fence.
to the table.
4. Clamp workpiece to
What to do
1. Position bowed material
clean with turpentine
and coarse steel wool
or household oven
cleaner.
size cord.
company.
hardware.
surface.
guide.
fence or glue 120 grit
sandpaper to fence
with rubber cement.
as shown in Fig. K.