Publicité
Les langues disponibles
Les langues disponibles
4
5
Remove all the parts from the front axle.
1. Slide a Ø12 washer onto the front axle.
2. Slide a front wheel onto the front alxe.
3. Slide a Ø12 washer onto the front axle.
4. Tighten a lock nut to the end of the front axle with a spanner.
5. "Snap" a hubcap to the front wheel.
Repeat the above procedure to assemble the other front wheel.
GAP
Attach the Front Wheels │ 6
2
3
After assembling any wheel to the axles, please check the gap between
the screw thread and the collapsible (refer to below picture), if the gap is
too big, please add two or three washers inside the wheel, but after
tightening the nut outside the wheel, please turn the wheel by your finger
to check if the wheel can run smoothly, this is very important, because if
the wheel can run smoothly, it is ok, but if the nut press the wheel and
the wheel can't run smoothly, the motor will be broken easily! Then you
need to decrease one or two washers to make sure the wheel can run
smoothly!
1
-7-
Front Bottom View
Publicité
