HOMCOM 370-190 Manuel De L'utilisateur Et D'installation page 23

4
5
Remove all the parts from the rear axle.
1. Slide the rear gear box onto the rear axle. "R" labeled gear box should be fit to the
"R" side of vehicle body; "L" labeled gear box should be fit to "L" side of vehicle
body. Keep the motor and the connector on the gear box pass through the larger hole
on the rear of the vehicle and out where the battery sits.
2. Slide the rear wheel onto the rear axle. And keep the driving wheel match up with the
gear box.
3. Slide the Ø12 washer onto the rear axle.
4. Tighten a lock nut to the end of the rear axle with a spanner.
Repeat the above procedure to assemble the other rear wheel. TIPS: An extra spanner
has been provided to hold the Lock Nut on the other side of the rear axle while
tightening the Lock Nut on the other side.
5. Fit a hubcap to each rear wheel.
2WD Attach the Rear Wheels │ 5
2
3
1
-6-
Rear Bottom View