Assembling The Trap In Four Steps - Biogents BG - Mosquitaire CO2 Manuel D'instructions

Assembling the Trap in Four Steps

1. Remove the BG-Basic dispenser (13) from the plastic pa-
ckaging [F1], and place it into the designated slot loca-
ted on the inside wall of the inner tube (8) [F2].
2. Place the funnel net (2) around the bottom of the intake
funnel (1) [F3]. Then place the catch bag (3) over the fun-
nel net. The funnel net is now located inside the catch
bag. Tighten the top part of the catch bag about 2 cm
below the top of the funnel net [F4].
3. Insert the intake funnel with the attached funnel net and
catch bag [F4] into the opening on top of the trap [F5].
4. Plug the bottom of the CO
respective wholes in the lid of the trap [F6].
emitter nozzle (10) into the
2
F1
1
2
F3
F5
F2
1
2
3
F4
F6
EN 5