Kapro CROSSLIGHT 3D LASER GREEN Manuel D'utilisation page 10

Working in Automatic mode (self-leveling):
In automatic mode the laser level will level itself within a ± 4°
range and will project 1 horizontal 360° and/or 2 vertical
360° green beams.
1. Remove the laser level from the case and place it on a
solid, flat, vibration free surface or on a tripod.
2. Push the locking switch #1 to the ON position.
All 3 beams will appear.
3. Press the beam selector button (a) repeatedly to see the
laser beams output pattern in the following sequence:
First press - Horizontal beam only
Second press - Horizontal and side vertical beams
Third press - Side vertical beam only
Fourth press - Front and side vertical beams
Fifth press - All beams (default)
4. If the initial inclination of the laser level is above ± 4°
and the automatic mode is activated, the laser beams will
flash rapidly and beep simultaneously.
In this case, reposition the laser level on a suitable
horizontal surface.
5. Before moving the laser level, slide the locking switch
#1 to the OFF position. This will lock the pendulum and
protect your laser level.
10
OPERATING INSTRUCTIONS