Publicité
Les langues disponibles
Les langues disponibles
8
AM/FM BAND SELECTOR
AUTO-STORE TUNING (AS)
SCAN TUNING (SCAN)
RADIO/CD MODE SELECTOR
During radio operation, each momentary press of this button will
change the radio band. The indication "AM", "FMI", "FMII" will
appear on the display panel according to your selection.
Pressing and holding the button for 0.5 seconds will activate the
Scan Tuning function which will scan the stations on the band in
use. The unit will stop at each station for 10 seconds before
continuing to the next station (the frequency on the display panel
will flash during Scan operation).
momentarily to stop Scan operation and remain on the selected
frequency.
Pressing and holding the button for longer than 4 seconds will
activate the Auto-Store Tuning function which will automatically
scan the AM or FM band in use and enter strong stations into the
pre-set memory positions for that band. If you have already set the
pre-set memories on the AM or FM band to your favorite stations,
activating the Auto-Store feature will erase those stations and enter
new ones. This feature is most useful when traveling in a new area
where you are not familiar with the local stations.
During disc play, pressing this button will stop play of the disc and
switch to radio operation without ejecting the disc. During this time,
the
DISC IN
indication will remain on the display panel to show that
a disc is still loaded in the unit. Pressing the button additional times
will change the radio band as well as return to disc play from the
point at which it was stopped.
All manuals and user guides at all-guides.com
Press the button again
-4-
9
MANUAL UP/DOWN TUNING (
AUTOMATIC SEEK TUNING
Each time the
button is tapped, the radio will tune one frequency
step higher. Similarly, each tap of the
frequency step lower. To manually tune in a station, tap the button
of the appropriate direction until the desired frequency is reached.
Pressing either button for longer than 0.5 seconds and then
releasing will activate the Automatic Seek Tuning function. The
radio will seek the next available station and stop at that frequency.
The Seek function can be stopped by pressing the button again or
activating any other tuning function.
Pressing either button for longer than 0.5 seconds will cause the
radio to continue tuning rapidly in the selected direction until the
button is released at which point it will seek to the next available
station.
bl
STATION PRE-SET MEMORIES
To set any of the 6 pre-set memories in each band, use the following
procedure:
1. Turn the radio on and select the desired band.
2. Select the first station to be pre-set using the Manual Up/Down
or Automatic Seek Tuning Controls
3. Press the pre-set button to be set and continue to hold it in. After
approximately 2 seconds, the display will flash and the volume
will be momentarily muted indicating that the station is now set
into that pre-set memory position. The station can now be
recalled at any time by pressing that button.
4. Repeat the above procedure for the remaining 5 pre-sets on that
band and for the other 3 bands on the unit.
/
)
button will tune one
9
.
Publicité
