Thermador PRO HARMONY PA30GLBH Manuel D'installation

Backguard Installation
Model 9" Low Back
30'' PA30GLBH
36'' PA36GLBH
48'' PA48GLBH
When using the Flush Island Trim, THERMADOR
recommends a minimum 12'' (305 mm) rear clearance to a
combustible surface. Clearances from non-combustible
materials are not part of the ANSI Z21.1 scope and are not
certified by CSA. Clearances of less than 12'' (305 mm)
must be approved by the local codes and/or by the local
authority having jurisdiction.
WARNING
State of California Proposition 65 Warnings:
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
Low Back Parts Included
1 – Low Back panel
8 or 9 – T-20 Torx stainless screws
8 or 6 – T-20 Torx drill point screws
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
English 1
PRO HARMONY
Backguard Installation
3" Flush Island Trim
Included with range
Included with range
Included with range
9001078744 • Rev. A • 5U06Y7 • © BSH Home Appliances Corporation, 05/15
Removing the Flush Island Trim
1. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim.
2. Remove the (4) drill point screws securing the trim to
the side panels, and the (2) to (4) drill point screws
securing the piece to the back panel. Lift up to fully
remove.
®